Edward Klepeis wrote:
Dear Paul
I have a question. What is the dia of tubing that everyone is using
for the rotary eng exhaust- in general with good
performace.Also is it better to go with seperate tubes out of the
block in to the muffler or Y them and go into the muffler with
a single tube. I have my own experience with subaru exhaust systems
but I know the rotarys run much hotter. I am looking at
trying to develop a exhaust system for the rotary
eng.
Regards
Ed
Tech Welding
Most are using 1-3/4" 2 inch in the racers.
32 inches before the Y if you want it tuned.
Use at least .065 321 SS in the parts close to the engine.
Especially if there are any bends in that area.
With the current engine you are looking at up to 1700 F
and super sonic shock waves in the pipe. It will eat just
about any stock muffler you can find.
The RX8 engine will be a bit cooler and not so violent.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.