You would not even notice it with nicely styled side plates.

You will not see it standing along side from any angle. You will only
see it if you lie down on the ground.

What do I have to do draw you a picture? :)


Paul Lamar

yah and it better be a pretty one =)
So make it like a P-51, figure out the boundary layer thing then run it 
all through the spanish airflow analysis software
comparing it to the same profile but exit elsewhere. in other words 
lets compare golden deliscious to golden deliscious, make it
emulate a good  P-51 then show it is as good or better.
...Chrissi

OK here it is. Can you even see it from this angle? :)
I don't need CFD to know that it is going to work.

Perry's works and it worked in the test box on the Van.
Also your money was used by Kays & London in a 20 million dollar
10 year investigation at Stanford. It worked for them too.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.