Well, shoot! Missed my chance for fame and glory {:>). I will
continue with
the project as I would like to have firmed data on what
my two radiators are
doing out there.
Ed Anderson
Ed, Thanks for the data. Since I probably missed it how big are your
2 rads? While the simple cooling system is indeed simple, I still
believe
there will be a sagnifigant drag penalty over a well designed ducted
system. One of the things being missed here is that turning the exiting
airflow into the airstream is another component of cooling drag. There
was a woman working for Adam Aircraft that gave a forum at OSH about it.
One of the reasons the P51 scoop worked so well is how well it let
the "bad" (read hot) air out. Bill Jepson
Bill, My two radiators are GM evaporator cores out of the junk yard for $5.
The fin area is 9x11x 3 3/8" plus the side tanks. I have a stock Mazda RX-7
Oil cooler under the nose. Here is are some photo of the cooling system
from the front and the coolers and their mounts. As you can see in the
older aircraft photo the ducts are generous in size.
My total radiator duct inlet area (before the reduction) was 48 square
inches, now down to 33 square inches with the left one now 9 square inches
and the right one still 24 square inches. I believe the sort of K& M
approach I took to smooth the inlet to radiator did help the cooling
otherwise I would have been overheating. However, I do not believe I could
also reduce the remaining duct to 9 square inches and not over heat. I
suspect the unmodified radiator is picking up some additional heat load.
However, my guess is that I could probable reduce both duct inlets down to
say 12 -15 square inches each. Won't be able to do that for a while, got
some other things on the burner that I have to get to.
Thanks for asking.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.