"Robinson, Chad" wrote:
Is it necessary to space the radiator away from the fuse to avoid the
boundary layer?
It depends on how far back the rad is from the nose and the angle of
the belly pan.
Would it be possible to simply angle it further from
the aircraft?
If the boundary layer is thick that might help but you would probably get less
drag by spacing it down a few inches and allow the boundary layer to flow
over the top.
I'm a little confused about whether the shallow angle at
which the rad is mounted is PART of the design (making a spacer desirable).
The shallow angle is because you only need about 30% of the rad frontal area
as an opening for the air.
Also, it seems as though some type of hinging system would actually be
quite beneficial. During cruise, and during periods when OAT was lower,
you might reduce drag by using a shallower angle because cooling is more
effective. On a warmer day you might sacrifice some of your speed
(due to drag) and drop the rad down to cool more effectively. We
all love to tweak - cowl flaps, prop pitch, etc. Why not a radiator pitch? =)
Yes this possibility has been mentioned.
I know this idea isn't new, but it seems as though when it was proposed,
it was mainly a side comment. Is it horrifically complex to engineer a
moveable rad because of plumbing or other considerations?
No.
Never having
done so, I'm curious about whether plumbing would make this a complex
problem - can flexible tubing be used effectively here?
Regards,
Chad
Yes.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.