Bill, My two radiators are GM evaporator cores out of the junk yard for $5.
The fin area is 9x11x 3 3/8" plus the side tanks. I have a stock Mazda RX-7
Oil cooler under the nose. Here is are some photo of the cooling system
>from the front and the coolers and their mounts. As you can see in the
older aircraft photo the ducts are generous in size.
My total radiator duct inlet area (before the reduction) was 48 square
inches, now down to 33 square inches
Ed, I ALWAYS listen to someone who is FLYING successfully. Let me
pass along some info you might find interesting. First:
depending on what you project your HP at you are using between
3 to 4 cubic inches per HP. The size of your rads indicates you
could probably do better with better ducts, good call on the mods.
One of the other things ignored by many is that Everett Hatch
used 2 rads IN PARALLEL. To successfully remove more heat one of
the best ways is to increase the mass flow of the water.
Everett understood that all things being equal more water
through meant better cooling. The only problem with the parallel
system is you must carefully balance the system so both rads pass
approximately the same amount of water. Paul is talking about
the e-shaft driven pump and this will help, IF it doesn't cavitate.
The other thing is that the standard pumps are real close to
cavitating to produce enough flow at high RPMS. Take another look
at the size of the water pump on the 900 HP Racing Beat
system. IT IS HUGE! Hang in there Ed. The simple system
may get more aircraft in the air, which is good. After that we need to
look at efficiency and to paraphrase an old southern
standard, The ducts will rise again! Bill Jepson
The only place you will ever get perfect K&M ducts is in the aft fuselage
like a P51. That is the only place with enough volume to do it right.
Most people are unwilling to cut large holes in the bottom of their
fuselages. We have been all over this years ago. You need to get one
of the NL CD's Bill and read all about how we got where we are
cooling wise.
For a canard forget it. There is not enough room anywhere.
Our best approach is to develop and have made a thin oblique rad.
There is a possibility something like that will work in a perfect K&M duct
only four inches high and 16 inches wide and eight feet long :)
Three feet for the inlet duct two feet for the oblique rad and three
feet for the exit duct. Is it worth it? :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.