George Lendich wrote:

Paul,
The Lads at the Machine shop.
CNC used on the bellousing.
Bellhousing Inside.
The PSRU mounting pad is machined parallel to the face as Butch suggested.
George (down under)

Looking good George.

Paul Lamar


****************************************************************************

Yep George, Looking real good ;)

George I suggested that the Psru mounting holes on the INSIDE of the hub, be
simply spot faced, or counter-bored slightly in order to provide a parallel
surface to the front face of the Psru's mounting surface in order to prevent
bending stress concentrations at the bolt's root thread.....Instead you have
machined the WHOLE rear surface, that's all well & good providing you have
the material to do so (Makes it Lighter), but you must make sure that the NET
thickness of this mounting hub is not violated.

I've read and possess your list of PI's, (Production Improvements) and at
this time I personally have NADA to add. It appears that you've been THINKING
and LISTENING very, very well ;-)

Congrat's!!!!..........Real nice job.

                                                     Butch

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.