Chris C, Microcosm.
That's good feed back, I beginning to get the feeling we can get the
weight
down to less than that with thin walls.
Paul,
The feed back I'm getting is that 4 mm walls is possible if the runs
(distance the aluminium has to run) weren't so long.
When I built the pattern, I used a 3 mm and a 2mm stiffener material,
I also
used a one layer bi-axial layer to give it strength.
Perhaps a 4 mm stiffener with one layer of fibreglass will give about
a 4.5
mm.
Also I put more than enough in the corners to give them a nice
radius -
this could be reduced.
The squaring -up of the corners of the MM sides added additional
material.
There is extra thickness in the PSRU mount plate and as you say this
can
also be reduced with some milling or pattern changes.
I guess I made the internal stand-offs a bit on the big side to allow
for
measurement errors and over-designing (as usual)
I would like to reduce the internal stiffeners but haven't a clue how
this
can be achieved.
As you can see there is a fair bit of savings before you start
cutting
into
the housing. I think the only way to do it to an absolute minimum is
to
start from scratch.
I will look at that in the next few days but don't want to get too
far
down
the track in case some further suggestions take things in another
directly
entirely.
George (down under)
George,
I think I'll still end up with a net weight savings because of
motormount interfaces I won't have to fabricate. Speaking of which,
will this handle the extra loads of the 20B? Any clue of the price
yet? No pressure, just budgeting.
Chris
microcosman.com/aircraft
Another thing....the top 3 bolts look like they'll be shorter. All 3
RWS sent me
weigh 239 grams, so whatever the difference ends up being.
Chris C.
microcosman.com/aircraft
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.