Subject: Bellhousing Tracy redrive adaptor bits weight.
From: ACRE
Date: 9/11/2003, 8:47 AM


George Lendich wrote:

Paul,

I turned-up a plug for the housing centre hole, to set the depth
of the ring gear to that of the starter gear.

As can be seen the ring gear fits perfectly in the top of the
housing with about 2 mm gap (between gear teeth and housing) .
The starter gear teeth mesh nicely with the ring gear.

Weight is down to 13.8 lbs, which is by no means the lowest
weight we can achieve.

George (down under)


Okay, Okay, I finally did something.  I just pulled the redrive off the
motor
and weighed the aluminum bits including the rear axial bearing seat on
the RWS RD1B and it's 4837 grams.  I think that's 10.64 lbs.

Chris C.
microcosman.com/aircraft

I think we can get some more weight out of George's bell housing once
I get it in my hot little hands. There are a bunch of 3 inch holes possible.
Also some pocketing around the center plate which could eventually go into
the pattern. I also need to see the wall thickness's. Perhaps we can get
it cast here in CA with thinner walls.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.