I vote for the largest display possible. I am getting old and it is hard
to see the instrument panel some times particularly in unusually lighting
conditions such as the sun dead ahead. Yes I know the sun does not shine
all that often in Florida :)
Much depends on all the features Tracy as perhaps some instruments could
be
eliminated to make space.
Give us a list of what this device provides.
Paul Lamar
OK, below is the list. It was designed to replace virtually *every* steam
gauge on the panel but there are a lot of pilots out there that want their
steam gauges but also want the limit & alarm features of a digital monitor
and would install the EM2 to get them. It has the ability to be field
calibrated to most any sensor in use so it can be put in parallel with most
existing installations without replacing anything. I'm tired of squinting
at my LCD engine monitor so the EM2 uses a VFD vacuum florescent display.
(see website for a picture (although the layout has changed from that pix).
1. Coolant Temp
2. Oil temp
3. Engine RPM
4. Coolant pressure
5. Left fuel tank level
6. Right fuel tank level
7. OAT (outside air temp)
8. Oil Pressure
9. Fuel pressure
9. Fuel Mixture
10. Fuel flow (GPH)
11. Fuel used since reset or gallons remaining
12. HP output (based on fuel flow & BSFC or rpm & MAP using an engine
index table)
13. % of power (based on HP & Engine rating)
14. Manifold pressure
15. Carb Temp (ice) (for those who refuse to go FI)
16 Aux 1 air temp (for experimenters measuring in/out rad temps,
etc)
17 Aux 2 air temp
18 Aux 1 liquid temp
19 Aux 2 liquid temp
20 System Voltage (alternator)
21 Flight timer ( oil pressure starts it)
22 Hobbs meter ( " enables it)
23 Hours since oil change
24 General purpose timer (seconds & minutes)
25 - 28 4 Cylinder temps (for Lycs or gen purpose temp measurements)
29 - 32 4 EGT temps (digital or bargraph) Highest one always
displayed in digital format)
33 Dynamic air pressure in " H2O for testing. (Added in honor
of Paul Lamar : )
Programmable High & Low limits on all engine functions. Alarm light or
audible alarm feed to audio panel.
In addition to the OAT mentioned above, the following air data is also
displayed.
1. TAS true airspeed (corrected for temperature & altitude)
2. Altitude (up to 32,000 ft)
3. VSI vertical speed
The EM2 also functions as a visual interface for the EC2 engine controller.
Shows the MAP table in bargraph form and allows you to edit it. Makes
"holes" in the table very obvious and easy to correct. For data logging,
engine parameters will be output via serial interface.
Price not set yet but will be introduced at under $1000 & will include basic
engine sensors.
Tracy
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.