Subject: EM2 Survey & Function List
From: ACRE
Date: 9/15/2003, 5:56 PM

Tracy Crook wrote:

Subject: EM2 Survey & Function List


OK, below is the list.  It was designed to replace virtually *every*
steam
gauge on the panel but there are a lot of pilots out there that want
their
steam gauges but also want the limit & alarm features of a digital
monitor
and would install the EM2 to get them.   It has the ability to be field
calibrated to most any sensor in use so it can be put in parallel with
most
existing installations without replacing anything.   I'm tired of
squinting
at my LCD engine monitor so the EM2 uses a VFD vacuum florescent
display.
(see website for a picture (although the layout has changed from that
pix).

1.  Coolant Temp
2.  Oil temp
3.  Engine RPM
4.  Coolant pressure
5.  Left fuel tank level
6.  Right fuel tank level
7.  OAT (outside air temp)
8.  Oil Pressure
9.  Fuel pressure
9.  Fuel Mixture
10.   Fuel flow (GPH)
11.  Fuel used since reset or gallons remaining

12.  HP output  (based on fuel flow & BSFC  or rpm & MAP using an engine
index table)

13.  % of power  (based on HP  &  Engine rating)
14.  Manifold pressure
15.  Carb Temp (ice)  (for those who refuse to go FI)

16  Aux 1 air temp        (for experimenters measuring in/out rad temps,
etc)

17  Aux 2 air temp
18  Aux 1 liquid temp
19  Aux 2 liquid temp
20  System Voltage (alternator)
21  Flight timer  ( oil pressure starts it)
22  Hobbs meter  ( "              enables it)
23  Hours since oil change
24  General purpose timer  (seconds & minutes)

25 - 28    4  Cylinder temps  (for Lycs or gen purpose temp
measurements)
29 - 32    4  EGT temps   (digital or bargraph)  Highest one always
displayed in digital format)
33            Dynamic air pressure in " H2O  for testing.  (Added in
honor
of Paul Lamar  : )

Programmable High & Low limits on all engine functions.  Alarm light or
audible alarm feed to audio panel.

In addition to the OAT mentioned above, the following air data is also
displayed.

1.  TAS true airspeed (corrected for temperature & altitude)
2.   Altitude (up to 32,000 ft)
3.   VSI  vertical speed

The EM2 also functions as a visual interface for the EC2 engine
controller.
Shows the MAP table in bargraph form and allows you to edit it.   Makes
"holes" in the table very obvious and easy to correct.    For data
logging,
engine parameters will be output via serial interface.

Price not set yet but will be introduced at under $1000 & will include
basic
engine sensors.
Did I forget anything?

Tracy



Tracy sent me this again. I don't think he gets half his email.
If you get this Tracy I have a question. All this stuff is not on one
display page is it? If not how many pages are we talking about.

Do you have any pictures of the display pages? I hope you have
a demo for the Oct Shady Bend flyin.

Paul Lamar


True, all that stuff will not fit on one 4 line, 20 character display.
Attached is a shot of the early layout of the frontpanel with the display
active.  The layout has been much improved since this picture but the new
panels have not come in yet.  I found the TAS function to be so useful that
the latest version has it added to the top line. There is also a Lycoming
version of the panel more appropriate for aircooled engines.

The top & bottom display line functions are permanently milled and paint
filled into the anodized panel.  These functions are always on-screen.  One
of my main squaks on the GRT EIS I use now is that none of the readouts are
labeled and I loose site of important engine data when other screens are
brought up.  The EM2 has 8 other variable engine & air data screens that can
be selected for the two center lines.  In addition, there are 2 calibration
and an EC2 interface screen.  My website has a picture of the EC2 interface
screen if anyone is interested.

The EM2 will be permanently installed in my plane by the October fly-in and
we'll have both large & small versions working on the bench hooked to an
engine simulator for show & tell.

 Data output for logging;  that will be available as an asynchronous serial
data stream at 19.2 kbs.  Have not finished the protocol for that function
yet.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.