Subject: Lightening holes in bellhousing
From: ACRE
Date: 9/16/2003, 6:53 AM

Russell Kent wrote:

Paul wrote:

If you don't cast the holes in George the cost of machining will be
much higher for you or for us than to put them in during the machining process.

If we have to do it on this end it is really expensive as it must
be done on an NC mill or on a rotary table and an ordinary
mill. No other practical way of doing it. Unless of course you
want to cut and reweld your band saw blade ten times. Once for
each hole.

At the risk of exposing the enormous depth of my ignorance, is there some reason
why the lightening holes couldn't be round and cut with a fly cutter (or other hole
cutting tool) on a drill press?  I do understand that holes made this way wouldn't
remove as much material and therefore wouldn't lighten as well as machined holes.

Russell Kent

Keep reading.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.