Edward Klepeis wrote:

Dear Paul
I would like to make a suggestion  on the welding of the intake 
manifold tubes. Use a tig torch with a gas lens main body.
This allows you to stick the tungsten out past the front of 
the cup  and allows you to weld into deeper corners. You can weld
half from the front and the rest from the back side to seal 
up the tube. If you have any questions give me a call.

Regards

Ed

techwelding@comcast.net

270 898 3776 shop

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.