Subject: RD-1C Good news / Bad news]
From: ACRE
Date: 9/17/2003, 9:42 AM


     Tracy Crook wrote:
     >
     > To those anxiously awaiting their RD-1C gear drives, here is the good news /
     > bad news story.
     >
     > Just got the results on some troubling spline fit anomalies with the RD-1C
     > propeller shaft. The problem was that a Genuine Ford planet carrier would
     > fit nicely on the shaft but an aftermarket part simply would not slide onto
     > the shaft. To the naked eye they looked the same and the major & minor
     > diameters measured identical.
     >
     > At first I though the aftermarket part was just made wrong and I would
     > simply have to use only Ford parts. On close inspection (backlit spline fit
     > with a 10x eye loop), it looked like the spline teeth only had a point
     > contact at the tips of the planet carrier spline teeth (this was on the Ford
     > spline). This would result in very fast spline wear, increased lash and
     > possible failure. The attached picture tells the story.
     >
     > After getting the data from Ford on the planet carrier spline it was clear
     > that the pressure angle on the prop shaft spline did not match the carrier.
     > Result: $7200.00 in scraped shafts. The only good news is that new shafts
     > are in process. Still not sure who absorbs the cost but either way,
     > someone gets the shaft. (please forgive tasteless pun) Actually, the
     > supplier has agreed that if the problem turns out to be what I just
     > described, they will accept responsibility.
     >
     > Isn't product development fun? I'll post an update to shipping schedule
     > when we have it nailed down.
     >
     > Tracy Crook
     > tcrook@rotaryaviation.com
     > www.rotaryaviation.com
     >

  Thanks for the info Tracy. I am still a few months away from needing 
it. I certainly hope that you don't get left
holding the bag. It is in all our best interests for your 
company to be kept profitable.

     Dick Gregory

Stuff happens. I had 20 scrap water pump castings I donated to the local
college so the machine shop students could get real world experience
machining a real casting.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.