Subject: 13B intake manifold "kit"
From: ACRE
Date: 9/20/2003, 9:22 PM


Paul,
We met at Arlington a few years ago...at David Adkins display.
I am building an RV-8 with a 13B turbo rotary.  Although I have the turbo and
Tracy Crook's ECM for turbo, I may go naturally aspirated due to my
experiences with turbo fires at work.
I noted your intake manifold "kit" (some assembly required) on Tracy's web
page, and used this contact address.

I am interested in your offering and would need to know if it is cast for the
turbo intake ports, and will it fit under an RV-8 cowl?
Have any aircraft engines flown or been ground run with this manifold?
What additional fabrication (plenum, vibration support etc.) guidelines are
recommended.
And, do you have units ready to ship?
Thanks in advance;
Scott Emery

Yes it will fit real tight down on the engine. The manifold will fit
the four port turbo engine with the stock 2nd gen turbo. 

I don't know if it has been ground run. We have only had it available for
a few months. Many have been shipped. It took us about two or 
three years to get it this far also however :)

Manifold is $185

Injector holders/bell mouths are $50 each and come in two sizes
to match the port size difference.

Add $15 for shipping. Can ship as soon as I get your check.

send check to:
Paul Lamar
830 East Santa Maria St. 
Suite 303  <<<<<<<<<<<<<<< VERY IMPORTANT
Santa Paula CA
93060

BTW do you want to be on the free email newsletter?

-- Paul Lamar The AirCraft Rotary Engine NewsLetter. Powered by Linux. ACRE NL web site. http://home.earthlink.net/~rotaryeng/ Copyright 1998-2003 All world wide rights reserved.