Here is the preliminary proposed casting.
Would you people want the built in right angle 1 1/2 inch
pipes or would you want it without the pipes so you could
weld on what ever?

Right angle tubing would cost up to $30 each  plus welding
so some money could be saved by casting them in.

This also has a couple of brackets for a rear motor mount.

I am still in the design stage so the brackets for the motor mount
will be beefed up somewhat over what is shown here even though the 
rear motor mount load is minimal for most motor mount designs. 

The availability of the casting will be well in the future but I 
have to get the pattern made in the 3D machine soon.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.