Subject: Single Rotor/AL End housing
From: ACRE
Date: 9/23/2003, 5:56 PM

Richard wrote:

Hi George,

I am working on the other single rotor. Have about 5hr run time on it. 
I am using compound end housings, meaning, the rotor
running surface is MAZDA and the outer part of the housing is AL. 
The weight saving is not as much as with a full AL housing,
but the developmental risk is nearly nil. I have not seen any problems 
in the areas I was concerned about most.
The water pump end housing can potentially be used on a two rotor, 
however, the PTO end housing is not designed to carry a
stationary gear.
I will have the engine with PSRU, but otherwise test Stand 
configuration, at Shady Bend Fly In.

Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.