Hi George
We have all the patterns made for the housings.
We have not had much time to work on them this summer, work,
rain, building new shop, rained out from that several days, etc.
We do have most of the engineering done and as we said the
patterns made. We also have some of the other details worked out.
It is not just an aluminum end housing project, but a light
weight single rotor engine. So there are many details to deal with
in all this. As you know from your bell housing project you
sometimes
have to redo something to get it right. Our project is to
have a single rotor engine that is lightweight, powerful,
and still run many hours under full load.
Royce
Royce,
Thanks for the response - it wasn't until after I sent that message
that I
remembered it was you doing the single
rotor.
Any photo's !?
George (down under)
All the components are going to Tracy and Laura's flyin, maybe we can
get Paul to shoot some.
Royce
Royce,
I'm sure he will do that - I'm keen to have a look myself.
George (down under)
Here are some old pictures from former Shady Bend flyins.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.