Subject: Single Rotor/AL End housing
From: ACRE
Date: 9/24/2003, 8:34 AM


Richard wrote:

Hi George,

I am working on the other single rotor. Have about 5hr run time on it.
I am using compound end housings, meaning, the rotor
running surface is MAZDA and the outer part of the housing is AL.
The weight saving is not as much as with a full AL housing,
but the developmental risk is nearly nil. I have not seen any problems
in the areas I was concerned about most.
The water pump end housing can potentially be used on a two rotor,
however, the PTO end housing is not designed to carry a
stationary gear.
I will have the engine with PSRU, but otherwise test Stand
configuration, at Shady Bend Fly In.

Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/

Richard,
Good stuff - how do you reckon two piece aluminium end housing would go with
the inside plate having the det gun treatment. The more I think about it, it
appears the easiest way to go.
Paul's steel plate would be better, if someone could find a way of doing it
successfully.
BTW I do like what your doing.
George (down under)
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.