Subject: cold rolled vs. hot rolled steel pipe
From: ACRE
Date: 9/24/2003, 10:30 PM


   I'm not needing to weld anything at the moment, just turning some
shafts to play with. I'll be yanking and tugging at them to see what it
takes to bend or pull apart.  I figure this will keep me busy for a year
or so. :)

   Side step:

   If I'm following you engine guys right, if a 13b is producing, say,
150 ft. lb.s of torque at 6000, it does  450 ft. lb.s at 2000 (3:1 prop
speed) rpm?

   If this is right, these two shafts need to carry at least 450 ft.
lb. each, plus some headroom.  Anyone have a spread sheet, website or an
"easy reader" book that gives guidance in calculating this stuff. :)
Such as:  2" od at what wall thickness to handle 450 ft. lb. of torque?
 I have charts for 4130 tubing up to 3", but nothing on pipe.  A little
math is cheaper than a pile of bent and twisted scrap pipe.

Phil Williamson



Two shafts Phil? No just the output shaft has 450 foot pounds.

If you drive two shafts the most you will get out of them when equally loaded
is half of 450 pounds. Other wise you would be doubling the HP of the
engine and we know that won't work.


  Shoot! You're right, the two would be dividing the load, hey, I said I
was going for headroom. :)

  Thanks for the book info Paul. I'll check our local CC for a materials
course too.  If not this  DOM seamless 4130, how can one get a strong
hollow shaft? Do you farm it out to somebody that can bore a hole down a
4 foot  piece of 2" solid  round stock, then turn it down for the
finshed OD?  I think I'll buzz up the the local CC and visit the
metalworking folks tomorrow.

Phil

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.