KSE sent me one of these for testing.
It is the same pump that Jim Mederer used on
his 1000 HP three rotor. Unfortunately it has two outputs.
Jim used a freeze plug to add an inlet to the block.
I am thinking of casting a single output housing for this
cartridge. It comes complete with shaft bearings so it
can be belt driven.
Shaft and cartridge are 27 oz. Housing is 23 oz.
KSE claims it puts out 60 GPM at 6000 RPM with a back pressure
of 60 PSI.
Paul Lamar
Paul,
Looks pretty good and a heck of of lot lighter.
Could the two outputs be reconnected with a Y connector and hoses? With the
Y being used to prevent flow restriction as opposed to a T and each intake
on the Y being the same dimension as the output of the pump but the output
of the Y being combined dimenison so it matches the total?
Vaughn.
Yes I think that will work. A lot cheaper than making a custom housing.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.