Archie wrote:
Why not simplify this.
My 1600hp dyno uses a solid drive of 1 1/8 dia.
Archie
Archie,
I don't want to pull this too far off the rotary subject. :)
I need two shafts, one inside the other. The RPM will be appx.
1000. They need to carry at least 450 ft. lb. (plus headroom) without
twisting. They also need to carry a tension load of 2500 lbs (plus
headroom) There will be a mount for a ballistic recovery system coming
down through its center, attached to the airframe.
This is for my twin 13b coaxial helicopter "project". :) I just
want to see if I can do it. No plans on trying to fly anything without
a full engineer consult. A few think I'm nuts, but once they understand
how I'll control it, they tell me I may be on to something. I have to
go for it. :) I've been "working" on this for so long it's like a bad drug.
Phil
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.