Archie wrote:
Why not simplify this.
My 1600hp dyno uses a solid drive of 1 1/8 dia.
Archie
What RPM?
Paul Lamar
Most run from 5200 to not usually much more than 9000.
Depending on the app, a couple of examples:
Ford 718 'lbs torque @ 4000
659hp @ 5000
Chev 700' lbs torque @7000
1100hp @ 9000
Archie
I don't see any 1 1/8 diameter helicopter shafts :)
This comment was not aimed at you Archie but a helicopter design
is something you want to get experienced professional help on.
Losing the rotor is guaranteed to ruin your whole day if not
the rest of your life.
Paul Lamar.
I need at least a 1.25" opening down the center. I won't do this
without the ability to have a ballistic recovery chute. I'll mount this
above the top rotor, connected to the airframe, through the top rotor
shaft. Just like those Army weapon/FLIR pods they mount on top. My whole
game plan is based on this. This sort of forces me to start with appx.
2" at whatever wall thickness I need to transfer the torque without
snapping or twisting..right?
Why can't I have a larger hollow shaft rather than a smaller solid shaft?
Paul, I understand you wanting me to get professional help. :) At the
moment, I don't feel I need it. There is much I can do in my back yard
without hanging on a set of rotors. I just don't want to mess with the
wrong material. I need two shafts. Yes, they are very large compaired
to most small helicopters. I have what *I* feel is a very unique way of
directional control for a coaxial helicoper. When the time comes, and
money allows, I'll hunt down an engineer..I promise. :)
At the moment, I'll assume if I go with DOM 4130 seamless pipe, I'll be
getting some pretty darn strong material with very good ID/OD specs.
Phil
Again there is no such thing as 4130 pipe.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.