Here is my latest design on the two piece end housing.
As usual I have made one part do two jobs. The standard O-ring
now seals the steel part with the light weight aluminum part.
Here too is the original two piece end housing idea.
I am getting to the point where I need to do a pattern
for casting the end housing in aluminum.
Perhaps I can buy the Al casting from Racing Beat without
the wear coating, mill it out with the NC mill and put in
the hardened sheet steel wear surface.
Paul Lamar
Paul,
I wouldn't pay that sort of money to chop it up - better still to make a
Prototype in a two piece aluminium and insert your steel face into a milled
section.
This way you can have reinforced areas for any faceplate mounting bolts
added-in during the milling process of the water jacket area.
This was along the lines I was considering and you can add in any sealing
grooves at the same time.
I'm still unsure how difficult the sealing will be in a two piece design,
but it seems to being overcome in your local single rotor design being done
by Richard.
George (down under)
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.