Dry sump pumps are not hard to make if you start with what is called
spur gear stock.
This is gear material that comes in 8 inch lengths up to 3 inch pitch
diameter. You
turn it down for bearings and seals between the several sections of oil
pumps
The first pump next to the drive end becomes the pressure pump as that
minimize
the torque on the shaft. The rest of the pumps in line are used for low
pressure scavenging purposes. You can buy spur gear stock from Stock
Drive
Products.
I have made some successful small pumps using spur gear stock
already. I'll work on a 3D for you sometime this weekend Doug.
Having an NC mill also helps.
Paul Lamar
Here is roughly what I have in mind. Picture the gears all on a one piece
shaft.
I think this could be made with a mill and a lathe but it would be a
little
tedious as there are several each of identical parts.
Paul Lamar
Paul,
Not knowing much about oil pumps and wanting to understand more - could you
show the oil path.
George (down under)
OK George.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.