Here is my latest design on the two piece end housing.
As usual I have made one part do two jobs. The standard O-ring
now seals the steel part with the light weight aluminum part.
Here too is the original two piece end housing idea.
I am getting to the point where I need to do a pattern
for casting the end housing in aluminum.
Perhaps I can buy the Al casting from Racing Beat without
the wear coating, mill it out with the NC mill and put in
the hardened sheet steel wear surface.
Paul Lamar
Walter Williams wrote:
hi Paul, who cast the al. side housings you just showed? what happened to
the co. that was going to cast them with a steel wear surface in place? I
was offered some rx8 rotors, does anyone know whether i can install them in
a series 5 or brew engine? thanks walt.
I think they are a product of Racing Beat.
My machine shop & foundry dropped the ball.
Check with Paul Yaw on fitting those RX8 rotors to earlier engines.
Right at the moment I see no reason why not. You will have to change
the balance weights of course.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.