BTW note that the rotor housing locks the steel sheet wear surface
against the aluminum end housing.
I guess this idea did not occur to me prior to the NC mill
as it
would be difficult to machine without one :)
Paul, This is a good idea, BUT, yes the classic but, I believe you will
have to make some kind of bond between the materials. The reason I mention
this is that in some of the earlier two cycle motorcycle engines we had problems
with voids between the iron cylinder liners and the aluminum casting. This always
led to a seisure with local origin. You could cut the cylinder up and easily find
the void area. These weren't large, like .002 in. Your idea is excellent. I drool
at the amount of weight we could remove from the 20B's! My concern though is the
thin plate would really like to become hot spotted. One possibility is to copper
plate both parts and silver braze them togeather. Just a thought. Bill Jepson
I don't think so. Heat transfer out of the side plates is not that important IMHO.
The rotary has so much surface area exposed to the combustion gases compared
to a piston engine that heat transfer to the aluminum water jacket is not all that
important. IMHO this "problem" has been overrated in the past. I have never seen
any evidence of any kind of failure between the steel liner and the rotor
housing and that is far far hotter than the side plates. Especially right
around the spark plugs. After all... they don't call it the rotating
combustion engine for nothing. The combustion chamber does indeed rotate
and therefore half the rotor housing and half the side plate area is
cooling the combustion process. This is of course a minor drawback
from a thermal efficiency point of view.
Perhaps a little silicone heat transfer white grease would be all that might
be needed. Would not hurt.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.