Subject: Latest two piece end housing idea.
From: ACRE
Date: 9/30/2003, 5:21 AM


BTW note that the rotor housing locks the steel sheet wear surface
against the aluminum end housing.

I guess this idea did not occur to me prior to the NC mill
as it
would be difficult to machine without one :)

Paul, This is a good idea, BUT, yes the classic but, I believe you will
have to make some kind of bond between the materials. The reason I mention
this is that in some of the earlier two cycle motorcycle engines we had problems
with voids between the iron cylinder liners and the aluminum casting. This always
led to a seisure with local origin. You could cut the cylinder up and easily find
the void area. These weren't large, like .002 in. Your idea is excellent. I drool
at the amount of weight we could remove from the 20B's! My concern though is the
thin plate would really like to become hot spotted. One possibility is to copper
plate both parts and silver braze them togeather. Just a thought. Bill Jepson

I don't think so. Heat transfer out of the side plates is not that important IMHO.
The rotary has so much surface area exposed to the combustion gases compared
to a piston engine that heat transfer to the aluminum water jacket is not all that
important. IMHO this "problem" has been overrated in the past. I have never seen
any evidence of any kind of failure between the steel liner and the rotor
housing and that is far far hotter than the side plates. Especially right
around the spark plugs. After all... they don't call it the rotating
combustion engine for nothing. The combustion chamber does indeed rotate
and therefore half the rotor housing and half the side plate area is
cooling the combustion process. This is of course a minor drawback
from a thermal efficiency point of view.

Perhaps a little silicone heat transfer white grease would be all that might
be needed. Would not hurt.

Paul Lamar

Leora wrote:

Hello- I am new to your list but have been gradually getting my eyes 
opened to the amazing possibilities of round and
round instead of up and down.
     On the end plates- if heat transfer is not that important you 
could have the al end housing and the wear face of the
rotor ceramic coated and let the 2 ceramic surfaces run against 
each other. I would expect to see an increase in exhaust
temp.  as one would be insulating the water jacket from the 
combustion area but that might not be a bad thing.  Any
thoughts  Bryan.

Wear coatings or platings of any kind on aluminum  have proven to be problematic 
over the long term. Apparently what happens is a minor failure eventually 
turn into a catastrophic failure. Small loose particles soon become cutting tools
that destroy the rest of the coating. Plated coatings on steel like
chrome have been fairly successfully. What is tried and true is hardened
or nitride 4130 or 4340 steel or plain old nitrided cast iron.

The automotive industry in general and Mazda in particular collectively
have spent billions on the compatibility of ferrous combustion seals 
(piston rings & apex seals) and the surfaces they contact.

Furthermore any of the more effective coatings or platings on aluminum have
proven to be very costly indeed.

Since there is little to be gained ceramic coatings are not worth
the risk IMHO.


Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.