George, The particular manifold shown is an unknown quanity.
My personal experience was on RX 2's and RX 7's used as road racers
and autocrossers.

Most of the Webber manifolds we saw had VERY LARGE runners as
far as the engine was concerned the entire manifold was like a big
vacuum plenum. Run very rich they could work well on the top end.

Mid-range sucked and off idle stumble were big problems, which
required you to run the low end even richer, to prevent stalling.
This wasn't just a webber problem. Many set ups were made using 4
barrel carbs which had similar problems. Most were just short
runners with a plenum under the carb V8 style The 4 barrels worked
better on these crude manifolds because the primaries were
small and gave a bit better low end.
If you are doing anything new George get a good fuel injection.
If you don't like Tracy's, Motec makes a good engine management
system with ignition and FI. A bit pricier though. Around 3K running.

Bill Jepson

Bill,

I do like Tracy's set-up and so do a number of Aussie Vision builders who
know a hell of a lot more than I do about engine management systems and
electronics.

There is an Aussie brand that has a good following and that is Microtec,
which I believe is starting to have some exposure in the USA. It's only
$1,100.00 here and that's about $700.00 US - however I don't think it's as
good as Tracy's, in so much that Tracy's is designed for Aircraft
application.

It's the exchange rate that is the killer for us down here!
I'm aware of the Motec.

Thanks for the response!

George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.