Here is something that might work to test different intake
systems.
Fill the large cardboard box with styrofoam packing popcorn.
These will be used to simulate large air molecules.
The smaller the pop corn the better.
Start the industrial vacuum cleaner with the port closed.
Turn on the motor with the rotating disk and time how
long it takes to empty the cardboard box of styrofoam
pop corn. Relate the length of the intake manifold section
to the RPM of the electric motor. You will need a high
speed motor capable of several thousand RPM. Some drill
motors might work. Other wise tuned pipes will be very long.
Now you can try different pipe diameters and lengths.
You could also build a Mazda DEI system out of cheap plastic tubing
and use a large Y in back of the disk. Each branch simulating
a rotor.
Much cheaper and much quicker than building a bunch of intake
manifolds.
Paul Lamar
Interesting.
A similar set up could be used to test the efficiencies of various designs of
the bifurcated portion of the runners,
One design, of course, is to cut and weld the pairs of runners together just
before they meet the carb., which may present some difficulty in
assembly/welding.
Another way would be to use small plenums for each pair of runners.
Am unaware how each of the above methods may relate to FAW.
Would be interested in knowing what constitutes a "good" and a "bad" manifold
system. Is this in the context of length/tuning?
Joe Graham
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.