Mark Supinski wrote:
Hi Paul -
I'm wondering how one goes about getting a 20b here in the US. I've looked
through the archives, and have noted some references to exporters. I have
also found that these engines will show up on Ebay on occasion
(http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33615&ite
m=2435733499 for example).
How would I go about determining whether any given engine is a good starting
point to build from? And, since it's clear I will have to completely tear
the engine down in order to rebuild it as an aircraft engine, what sort of
costs should I be looking at "raw"? The engine cited above seems like it
has all the basics I would probably want, but from some of the numbers
thrown around here seems a bit on the high side?
Most importantly, what sort of questions would one try to get answers to
before committing to any given engine? It's clear that on the 13's the
production year is a key metric -- the list is full of examples where some
series of the engine are much better suited to aircraft use than others.
Finally, what sort of lead-time would be prudent to get an engine delivered
before expected kit completion? I'll be having rebuilding help from an A&P
friend, but don't yet have a clear understanding of the man-hours I'll be
committing to the engine project.
Thanks for insight into these 'newbie' questions...
Regards,
Mark Supinski
Prices vary all over the map. Could be as little as $2500 to up to $8000.
I think they all are pretty much the same as they only made them for about
eight years. Some have been built up out of 13B parts using the unique
3 rotor intermediate housing and shaft still available from Mazda
Racing.
Like any rotary the compression is all important. You take
the schrader valve out of a cheap compression tester and turn
the engine over with the starter enough to get hopefully at least
three equal pulses in a row on the compression gage for each
rotor. One after another.
Of course even an engine with bad compression can be rebuilt perhaps
requiring new rotor housings at about $400 apiece as I recall.
Could be more now. Worst case is damaged rotors that also need
to be replaced. Usually the end housings can be re lapped if worn
beyond specs. If the apex seal slots in the rotors are worn
they can be ground out for 3 mm seals instead of 2 mm stock seals.
The latest shade tree trick is gently hammer the slots to close
them up a bit and then re grind them for 2 mm seals or do nothing
else at all. Perhaps clean them up with a jeweler's file.
It usually takes longer to clean the rotors than anything else.
A fast mechanic can completely disassemble the engine in 30 minutes.
It may take as long as an hour to put it back together. It takes
about 8 hours to clean each rotor :)
Of course all elastomer seals need replacing and I highly recommend
replacing all O-rings, both oil and water, with 500 degree F Teflon
Encapsulated Silicone. TES O-rings. This provides an additional safety
margin for the inadvertent over heating both the oil and the water.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.