Subject: Off Topic - Shop air and high humidity
From: ACRE
Date: 10/8/2003, 9:24 AM

"Webre, Steven P." wrote:

Folks,

Know this is off topic, but those living in high humidity areas might be
interested....

I use a lot of shop air for my other hobby (antique engines) and in S.
Louisiana, humidity in the system is always a problem.

Basic set-up is a large vertical 5 hp compressor (Sam's variety) and the
usual assortment of galvanized and PVC pipe w/ drain points.

When running the blast box, the compressor runs to the point that the
whole accumulator gets very warm.  Lots of water drops out, but this hot
air at saturation point still carries a fair amount of moisture
downstream. Small commercial moisture traps at equipment help but don't
eliminate when running hard.

Upshot is that I mounted a "large" (~10" x 12" x 5/8"?) Hayes
transmission cooler on the plastic shroud opposite of the compressor
pulley/fan.  Cut off hose barbs and tubed it in between compressor and
tank.  Air flow doesn't seem to be much but results are excellent.  Temp
leaving the compressor is 160+, but cooler temp is ambient at about
halfway down.  Tank remains at ambient and compressor head fins seemed
no hotter than usual.

First long session at the box last night w/ outside air at 100% humidity
(temp/dewpoint less than 1) gave excellent results.

Also picked up an automatic drain kit on sale from Harbor Freight.
Simple installation, cheap ($17?) and seems to work like a champ.

Now, we'll see how long it last....

Steve Webre
Broussard, LA


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.