Subject: Cooling Problem Solved! Air trapped in the cooler?
From: ACRE
Date: 10/9/2003, 9:40 AM


In the picture below it shows exactly what I mean:
It seems to be the typ of oil cooler that is single pass (looks like the
ones Robinson also uses in its helicopters, Steward-Warner, South Wind
Inc.). If it does not get bled correctly it will trap air, at least if
installed like below!
Now two questions for the physics-up to date!:

Lets say the oil goes only to 1/4 of the hight of the cooler at 1 bar. What
oil-pressure do the 13Bīs run? How much would this compress the air in the
cooler at roomtemp.? How much more cooler cross section would now be
available for cooling?
How much would the resulting smaller air volume re-expand when things get
hot (what is the regular inlet temp for the cooler?)

Robinson installs the coolers flat (horizontal), which means air could/does
get trapped for less than half of the width of the cooler. Maybe this
position would help to finally force the air out. Still inlet and outlet
lines turn down immediately after they leave the cooler.

Does anyone have any connections (engineering or so...) to any cooler
makers? They should know best!

Thomas J.


13B's non racing run up to 90 psi. That sounds plausible for a single
pass oil cooler but most if not all Mazda oil coolers are two pass.

Paul Lamar


Dave Arbogast wrote:

Doesn't the air eventually, one "droplet" at a time, all leave the system? It
certainly would be forced out of the small passages where the bulk of the
cooling is done anyway. I don't think we calculate the cooling area to include
the surface of the end tank where the air would be pushed to anyway.

When I worked for Federal Mogul's research lab, it was a standard design
consideration that these air droplets would be in the oil stream until they were
all forced into the sump.
 --
-dave
mailto:dave@arb.net
http://arb.net

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.