Subject: Plugs and wiring: was, crank angle sensor plug
From: ACRE
Date: 10/20/2003, 11:56 PM


I cut the plug off, and soldered my aircraft grade wire to the
wires on the crank angle sensor, and used heat shrink over the joint.

IMHO

Steve Brooks


Steve, After trying many different connection methods, the services 
stopped soldering. They found that the wire area adjacent to
the solder would break. The Navy found this to be particularly 
bad in salt air. They use crimp connectors and pins for
connections and wire to wire crimps for permanent connections. 
Most A&P's use crimps for radio gear as well. Most of the
automotive mfrs. use a sealed plug and silicone grease with 
the crimp pins. Amp, Molex and several others sell the plugs and
pins.

That said if you don't want to buy a $300.00 crimp tool, careful 
soldering is OK, but seal the joint as you did with the shrink.
I use alcohol to be sure all the flux is cleaned from the joint 
also. Be sure to use only rosin core solder as acids will
embrittle the joints.

These comments may seem longwinded, but most of the failures 
in homebuilts are NOT major mechanical failures. The most common
problems are fuel delivery and electrical systems failure. 
Most of these problems happen in the first 20 hours.
Bill Jepson

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.