Do it like I did after Mazda refused to sell me anything but a $500.00
plus wiring harness.
Buy matching male and female plugs, cut the wires and install the new

plugs.

Total cost $2.90.

Hank Huddleston

Steve Brooks wrote:

I think that any plugs are a failure point.  When they get wet, they
corrode. I cut the plug off, and soldered my aircraft grade wire to the
wires on the crank angle sensor, and used heat shrink over the joint.

IMHO

Steve Brooks
Cozy MKIV
Mazda 13BT

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.