I cut the plug off, and soldered my aircraft grade wire to the
wires on the crank angle sensor, and used heat shrink over the joint.
IMHO
Steve Brooks
Steve, After trying many different connection methods, the services
stopped soldering. They found that the wire area adjacent to the
solder would break. The Navy found this to be particularly bad in salt
air. They use crimp connectors and pins for connections and wire to
wire crimps for permanent connections.
Most A&P's use crimps for radio gear as well. Most of the automotive
mfrs. use a sealed plug and silicone grease with the crimp pins. Amp,
Molex and several others sell the plugs and pins.
That said if you don't want to buy a $300.00 crimp tool, careful
soldering is OK, but seal the joint as you did with the shrink.
I use alcohol to be sure all the flux is cleaned from the joint also.
Be sure to use only rosin core solder as acids will embrittle the
joints.
These comments may seem longwinded, but most of the failures in
homebuilts are NOT major mechanical failures. The most common problems
are fuel delivery and electrical systems failure.
Most of these problems happen in the first 20 hours.
Bill Jepson
Steve Brooks wrote:
Bill,
You make some excellent points, and I was careful to get a good solder
joint, without allot of excess solder either, which can lead to breakage
issues. I had used the crimps to start with, but I just didn't like the
result for making the butt joints. I used allot of crimp connectors,
however, when terminating the wires on breakers, relays, terminal strips,
etc. Not really allot of choices there. I have seen allot of trouble over
the years with connectors on cars, boats, trailers, etc. I think that they
are a definite failure point.
Steve Brooks
I think that one of the problems NASA has with solder is the solder tends to
wick up the stranded wire inside the insulation and that causes a stress
concentration. If the wire is allowed to vibrate it sometimes cracks right were
the solder stops. Near impossible to detect this before it happens and it
is then too late.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.