Hi, fellow rotary enthusiasts....I am trying to finish wiring up my

Mirco-Tech ECU.

I am at the stage where I need to wire up
the crank angle sensor.  My CAS already has the Mazda, or factory

plug

on it.

Does anyone have, or know where I might obtain
the mating plug to complete my wiring? Thanks in advance for your

replies. Paul Conner

Paul,
Where are you based?
Why did you choose Microtech.
George  (down under)

 Hi, George....I am based in Mobile, Alabama.  I chose the Mico Tech only

because that is what Dave Atkins of Atkins Rotary sells with his Electronic
ignition/throttlebody package.  I do like the fact that most of it is pre
wired, including injector plugs, etc and that it uses a panel mounted
controller that eliminates the need for a laptop computer. The package also
includes the TWM throttlebody, intake manifold, fuel rail, fuel pressure
regulator, fuel pumps, sensors, etc, etc. Nearly a bolt-on intake and fuel
injection system. Hope this answers your question sufficiently.  If you have
any other questions, please fire away....I will do my best to answer them.
Paul Conner, 13b powered SQ2000 almost finished.

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.