Subject: Surf Cam or Master Cam?
From: ACRE
Date: 10/31/2003, 9:26 AM


Paul, I meant to ask in my previous post if you have a CAM program? 
If so have you used it? The composite shop I work with is
talking about getting a Haas Mill. I wondered if you have used 
one of the programs. I have done all my mill programs the old
fashioned way by typing out G code. (dating myself there)
Bill Jepson

I just happen to have Master Cam but I am still not up to speed on
it. I don't know which is better. I do know that Master CAM accepts
Rhino IGES.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.