The owner of one of the most prestigious aluminum foundries in
the US has been converted to a rotor head. I showed him a picture
of Tracy winning the Sun 100 race and he offered to develop
aluminum end housings at no cost to us. A good example of
the synergy between air racing and changing the hearts and
minds of untold thousands about the rotary.
He has the technology needed to embed low cost steel wear surfaces in the
aluminum end housings. He already makes thousands of aluminum car wheel
centers with inserted steel parts that are welded to steel rims. His
car wheels so designed and constructed have survived millions of fatigue
cycles in industry standard wheel testing rigs.
He has also agreed to develop an aluminum three rotor intermediate housing
which is a key to the continued availability of the three rotor engine.
Anybody with an NC lathe can make three rotor eccentric shafts
but the three rotor intermediate housing is another matter entirely.
We need to beg borrow or buy a three rotor intermediate housing new or used.
If you have one you are not using contact me.
Paul Lamar
Paul, I still have email in my inbox from last April, just not enough
time to read it all. Ran accross this, anything happening?
--
Perry Mick
http://www.ductedfan.com
Unfortunately no. The machinist end of this consortium dropped the ball.
I am still interested and I may sometime in the future use my NC mill
to make patterns for aluminum end housings with steel insert wear surfaces.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.