Subject: Single rotor E-shafts
From: ACRE
Date: 11/6/2003, 7:26 AM


Richard wrote:

My 2c worth.

Here is a picture of the e-shaft I am using in the single rotor. It has run
about 5hrs so far. It has a 30mm taper for Rotax/Hirth interface.
This design does not need rehardening and grinding, it uses an inner race of
a needle bearing the same size as a Mazda bearing.
Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/

Hi Richard, I did not get any pic of your E shaft, could you post it
again and give some info and the ident of the needle bearing that you
got the inner
race from? Tks, Dave McC, EuropaXS

Here is the e-shaft pics from my files Dave.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.