.....This is general common practice especially in the Aerospace and

[Butch, If it's good enough for them it's good enough for me!!]

##If it's OK with you I may decide to put a little one in, for piece

of

mind

******It's okay with me, there's nothing wrong with belts & suspenders

in

this area.....You now have 2 PLACES....Just keep reading Georgie.

 Finally I won't have any problem with these corners- not at all !!

.....So again, I'll have to explain this over a glass of "Red"

sometime.....(These glasses are turning into bottles) :)

[You talked me into it !!]
!!

******Georgie the attachment is going to put a great big SMILE in your

face.

I made a couple of add'l changes in this area that was bothering me and

you

too.....I changed the Armpit radius by the 2 bottom Flange mounting

bolts in

question, from 25mm (.985") to 60mm (2.36") Radius, this will require 2
internal Bulges now.

[Ah yes!! I like that much better Butch!!]

[I know I mentioned the corners being sharper than I wanted, however you
must have read my mind on the RH bolt pad  and how it now blends into the
new flange - that was my next request ( these are only minor things, I
thought I'd leave for last).
I'm sure you would agree to doing a similar exercise to the Top LHS bolt pad
and Lower LHS pad.]

George

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.