.....I changed the Armpit radius by the 2 bottom Flange mounting
bolts in question, from 25mm (.985") to 60mm (2.36") Radius, this will
require 2 internal Bulges now.

[Ah yes!! I like that much better Butch!!]

[I know I mentioned the corners being sharper than I wanted, however you
must have read my mind on the RH bolt pad  and how it now blends into the
new flange - that was my next request ( these are only minor things, I
thought I'd leave for last).
I'm sure you would agree to doing a similar exercise to the Top LHS bolt pad
and Lower LHS pad.]

George

******************************************************************************

Yes Georgie, you did mention it to me, that's why I knew this was going to
warm the cockles of your heart.....So you see, I do listen also :)

This is all part of what I refer to as "Cats and Dogs" and there's still a
few more to go, so you'd better not be doing any pattern making yet until you
get my AutoCad dwg file as you may get surprised/shocked ;-)
Don't forget there are 9 Ribs total, 1 Full Wrapped Around (Top)...2 Columned
(Bottom L/R)...6 sets of 2 Triangles.

Attached is the updated capture.

Butch

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.