.....I changed the Armpit radius by the 2 bottom Flange mounting
bolts in question, from 25mm (.985") to 60mm (2.36") Radius, this

will

require 2 internal Bulges now.

[Ah yes!! I like that much better Butch!!]

[I know I mentioned the corners being sharper than I wanted, however

you

must have read my mind on the RH bolt pad  and how it now blends into

the

new flange - that was my next request ( these are only minor things, I
thought I'd leave for last).
I'm sure you would agree to doing a similar exercise to the Top LHS

bolt pad

and Lower LHS pad.]

George

****************************************************************************
**

Yes Georgie, you did mention it to me, that's why I knew this was going

to

warm the cockles of your heart.....So you see, I do listen also :)

This is all part of what I refer to as "Cats and Dogs" and there's still

a

few more to go, so you'd better not be doing any pattern making yet

until you

get my AutoCad dwg file as you may get surprised/shocked ;-)
Don't forget there are 9 Ribs total, 1 Full Wrapped Around (Top)...2

Columned

(Bottom L/R)...6 sets of 2 Triangles.

Attached is the updated capture.

Butch

Butch,
Understood!
I'm currently working on the bathroom, so no work on the bellhousing!
George

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.