I am just getting around to wiring Tracy EFI/IGN computer
and I had an idea. Tracy uses a 37 pin D sub min male connector
that is rather hard to attach tiny wires to unless you are real good
with
a tiny soldering iron or you have a special crimping tool.
This is a job I was not looking forward too as my eyesight
and hand coordination is not what it was when I was younger.
I was driving home from the hangar tonight and had an idea.
I have a whole bunch of these terminal strips left
over from another project and I had the idea of making a small
printed circuit board that would adapt a male 38 pin D sub min
printed circuit board connector to these easy to use terminal strips.
Merely strip the wire, insert it in the hole and tighten the screw.
I am laying out the PC board and will order a bunch of mating male
38 pin D sub min connectors to solder to the printed circuit adapter
board. If anybody wants such an adapter let me
know. Cost should be around $20 or $30.
Paul Lamar
Rob W M Shipley wrote:
Boy! You'd better make sure Bob Nuckolls doesn't hear about this idea.
:-]
Rob
Rob W M Shipley
RV9A N919RV (res) Fuselage
OK I'll bite. Why?
Paul Lamar
Rob W M Shipley wrote:
Because of his disdain for increasing the parts count and number of
connections in a circuit and for his dislike of screw connections. His
book, The Aeroelectric Connection, will give his rationale - one which has
become very widely accepted amongst homebuilders. Since you certainly count
as one of homebuilding's enquiring minds I'm rather surprised your bookshelf
lacks a copy of this important book.
Rob
In my 25 years of manufacturing electronic test equipment I have found
that screw connections are not all that bad. Heck if it bothers you
just use Loc Tite thread lock.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.