I am laying out the PC board and will order a bunch of mating male

37 pin D sub min connectors to solder to the printed circuit adapter
board. If anybody wants such an adapter let me
know. Cost should be around $20 or $30.

Paul Lamar

Paul, at work we use connectors from Phoenix. Thay may make a connector
of tis type already. I'll check, it would save you the
making the pc board. Bill Jepson

Makes sense to me. There should be something out there like this.

Paul Lamar

After reviewing the installation instructions on the EC2 it looks
like it might be better to have 15 pin D sub min on the printed circuit
board as well to connect to Tracy Programming & Control Module. PCM for short.
15 fewer terminal blocks would then be required.

Pins 5,6,10,14,15,16,24,25,26 and 32 all go to the PCM. In that case
a 15 wire, off the shelf molded cable with 15 pin D sub min connectors 
could be used to connect to the PCM located on the instrument panel.

This would further simplify the wiring and speed the installation. 
I'll work on the 3D for that.

Tracy, will this idea also work on the latest EFI/IGN system and the EM2?


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.