I am just getting around to wiring Tracy EFI/IGN computer
and I had an idea. Tracy uses a 37 pin D sub min male connector
that is rather hard to attach tiny wires to unless you are real good with
a tiny soldering iron or you have a special crimping tool.
This is a job I was not looking forward too as my eyesight
and hand coordination is not what it was when I was younger.

I was driving home from the hangar tonight and had an idea.
I have a whole bunch of these terminal strips left
over from another project and I had the idea of making a small
printed circuit board that would adapt a male 38 pin D sub min
printed circuit board connector to these easy to use terminal strips.
Merely strip the wire, insert it in the hole and tighten the screw.

I am laying out the PC board and will order a bunch of mating male
38 pin D sub min connectors to solder to the printed circuit adapter
board. If anybody wants such an adapter let me
know. Cost should be around $20 or $30.

Paul Lamar

Rob W M Shipley wrote:

Boy!  You'd better make sure Bob Nuckolls doesn't hear about this idea. :-]
Rob
Rob W M Shipley
RV9A N919RV (res) Fuselage

OK I'll bite. Why?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.