"sqpilot@earthlink" wrote:

Hi, fellow rotary enthusiasts.  I finally finished assembling 
all the pieces for my intake manifold. I'm looking for a welder
for final assembly.  I'm afraid that if I take it to a local 
welder, that the tubes will be out of alignment by the time I get
it to the welder. I seem to recall that Ed Klepis (spelling)? 
said that he has a 13b engine, so he might be able to tack weld it
in place, then remove it for finish welding, then it will fit 
properly. How about it, Ed?  Sure could use a professional welder.
Attached are a couple of photos showing what is involved.  
Thanks for any and all assistance.  Paul Conner

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.