George Lendich wrote:

properly. How about it, Ed?  Sure could use a professional welder.
Attached are a couple of photos showing what is involved.
Thanks for any and all assistance.  Paul Conner

Paul,
Using only two pipes will require fairly big injectors (or are you using
4) - anyhow you have taken an off-the-shelf manifold , cut off the top
because it is sloped for the car use and will attach 2 aluminium pipes etc.

A Question if you don't mind:-
Have you  calculated the diameter of the 2 pipes to allow for the usual
things.

Do you have some knowledge on this subject that
indicates that this set-up will be satisfactory and can you explain your
rational - as I'm thinking of going the same way, but don't want to restrict
intake !!
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.