David Carter wrote:

I'm filling out the "RV-6/6A Special Finishing Kit Order Form" - to be used
by those NOT buying the Lyc from Van's.  On the back it shows 3 types of
engine mounts that are available:
    - Dynafocal 1 - lines from rt & left converge about center of fwd rt
cylinder (looking down from above engine)
    - Dynafocal 2 - lines from rt & left converge at front of crankshaft
(same view from above)
    - Conical - Holes parallel (same view from above)

I'd like to know if one of these three is easier to modify to mount a rotary
engine than the others;  or, are there  pros and cons for each?

David Carter
RV-6, Nederland, Texas

It is easier to start from scratch. Save the money and don't buy
the mount from Van. Jerry Hey builds a very nice and strong mount.
If that is not possible Jerry can start with any of them and cut off
what is not needed. In that case buy the conical as it is probably
the cheapest.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.