Subject: Tracy & Bruce new apex seals.
From: ACRE
Date: 11/13/2003, 10:26 PM


 > Bulent Aliev wrote:> > > > >> > > > > What about the new 2mm apex seals
that Tracy demonstrated against> the> > > > > factory ones. Very impressive.> > > > > Bulent> > -"Brian D. Cain"
wrote:> > >> > > We'll be building two engines using Tracy's new 2-piece 2mm apex seals> > > and springs pretty soon.  Both of
them will be in a high powered> environment> > > so I'll> > > be anxious to see how they perform.  I expect good things from
them.> One of> > > our friends> > > in Canada is using his stuff and, although he's satisfied, he's told me> that> > > they had
an> > > extensively long break-in period of 1800 miles (automotive miles, that> is).> > > I'm assuming> > > the engine in
question is using re-used rotor housings as well so that> may> > > be part of the reason behind it.> > >> > > B> > >> > > Brian
D. Cain -/- Grand Prairie, TX -/- bdc196@comcast.net> > > BDC Motorsports - Performance Rx-7 13B Rebuilds, EFI tuning,
etc.> Yes, longer break-in time when used on used rotor housings is the price you> pay for the increased durability.  BTW,  the
testing period is now over and> the "Not recommended for Aircraft use"  limitation is now gone.  No failures> so far, even on a
turbo installation that ran into detonation.  Don't know> if you could hear it in an airplane but detonation is *definitely*
 audible> in a car.> > Tracy Crook 


For those of us that weren't at Shady Bend please tell us what was demonstrated 
there reguarding the new apex seals. What was
done to show they are better than say, Hurley's and others including the new factory 2 piece?

Jim Brewer

Nothing was done along those lines to my knowledge. I may have missed
something however. Seems to me the only proof would be long term
testing in a working engine. Something like 2000 hours. It is hard to 
simulate the environment an apex seals is forced to work in.

I was thinking about that on the way home from the hangar. If I were very wealthy
and I wanted to test apex seals I would set up Mazda engines as generator
sets and generate all the power for shop and home. I would use the waste heat 
to heat hot water and heat the house and shop in the winter time. I would then
sell the excess power back to the power company. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.