Subject: Tracy EFI/IGN wiring break out board.
From: ACRE
Date: 11/13/2003, 10:23 PM


Here is a first cut on the PC board.
The large holes are for tie wrapping the wires to the PC board
for strain relief.

As far as terminal blocks are concerned they are functionally
equivalent to a crimp connector which are preferred by NASA
over solder connections. You just need to make sure the screw does
not loosen. A drop of hard wax or RTV ought to do the trick.
Loc Tight screw lock will also work.

BTW a subtle advantage of this approach is a wire size can be used
that will match the wire size Mazda used for all of their engine
connections. 22 to 24 gage wire typically found in D sub min
terminated
cables is a bit on the small side for automotive wiring harnesses.
It is not that it won't carry the low currents involved it is
just a little harder to work with when connecting to automotive
connectors used on the ignition modules and the fuel injectors.

There is also a picture of the connectors used. The 15 pin right
angle allows an off the shelf 15 wire cable to connect to Tracy's PCM
module. There will be three of the ten contact terminal blocks.

The layout shows only one ten terminal using and two eight's
but I ran out of pins so I will use three tens.

The 37 pin male connector on the top left plugs into Tracy's
37 pin female connector on the top of his box.

Paul Lamar

Looks good Paul.  Only question I have concerns the mechanical fit - you 
say the 37 pin dsub plugs into Tracy's unit...  I have not seen his 
ECM yet, tho plan on getting one when I get to that point, but will 
his box allow for mechanically securing the assembled break-out board 
connector and the ECM connector together?  

There are two 4-40 screws on each end of the 37 pin female connector
on the top of Tracy box. You could also drill some holes in the top
cover and use short stands off to further secure the adapter board.


I assume you could plan for holes through the fab board to allow screws 
to go through both, and if that's the case, then you will want to route 
the traces around those holes.

Yes I made that mode today.

I would not want to use something on an aircraft with this much mass 
plugged into a connector without some way of securing it.  That being 
said, I appreciate the effort you're going through, and would like to
 use your fab board when you get done - thanks!

Grant Schemmel

Your welcome Grant. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.